New Innomedia Password?

When trying to log in as admin to your Innomedia box, try:
Username: Admin
Password: password

Upgrading Linksys Firmware

From DSLR:

On the Linksys, web admin access is disabled. To enable it, pick up phone, dial **** then 723646# , when asked for password, dial 78778839# , when asked for value dial 1# then dial 1 to save.
Then, go to »192.168.0.1/admin/voice/advanced , enter user and password.

If gizmo behind router, you also need to enable access from WAN side with option 7932# . Of course, substitute gizmo WAN address in above URL(Important part... I had to use the IP my router assigned my ATA to access it). To hear it, use option 110#, when asked for value dial 1# then dial 1 to save

User:admin
Password:7UprUtew
just turn off provisioning (or set up to provision from new provider) and be careful not to do a factory reset since thus far nobody knows the default SunRocket password.

I then changed the password on the advanced system page.

I also removed the Configuration Profile/Profile Rule: string from the provisioning page along with the Firmware Upgrade/Upgrade Rule: string (so no provisioning would happen and allows me to leave firmware upgrade/provisioning enabled).

Next I went to the linksys support page and downloaded the firmware update.

I followed this by extracting the update and running it.

Finally I entered the IP my router assigned the SPA with my admin password I created, and started the flash it took ~90sec and the ATA rebooted.

I then logged back into the ATA with the IP from last part and looked over the settings.